Kemppi Master S 400 User Manual

Master S400, 500Operating manualBruksanvisningGebrauchsanweisungManual de instruccionesKäyttöohjeManuel d’utilisationManuale d’usoGebruiksaanwijzingBr

EN3.2.3 Activation and setup parameter adjustment1. Press remote selection button (11) for at least 3 seconds, until the text ”Set” appears on the s

EN3.3 MMA weldingIn manual metal arc welding (MMA), the ller material is melted from the electrode to the weld pool. The rate of welding current is

ENSite your equipment in a suitable location, ensuring there is adequate cable length to complete the weld pass. Before you start welding, ensure you

EN3.4 TIG weldingNOTE! In TIG welding the welding cable must be connected to the negative (-) pole connection socket and the earth return cable to th

EN3.5 Carbon arc gougingConstant voltage (CV) mode is recommended to be used with carbon arc gouging. In CV mode the voltage is adjusted. Gouging is

EN4. MAINTENANCENOTE! Watch out for mains voltage when handling electric cables!Degree and circumstances of machine utilisation should be taken into

EN5. TROUBLESHOOTINGThe control panel will display any errors of the system. Error code numbers are shown in the display and can be compared to the t

EN5.2 Control panel error codesError 1 (E1)Power source is not calibrated. Calibrate power source.Error 2 (E2)Undervoltage Check the mains network co

EN6. ORDERING CODESMaster S 4006321400Master S 5006321500Master S 400 Celincluding cellulose welding characteristic 632140001Master S 500 Celincludin

www.kemppi.com1910110 1418KEMPPI OYKempinkatu 1PL 13FIN-15801 LAHTIFINLANDTel +358 3 899 11Telefax +358 3 899 [email protected]

OPERATING MANUALEnglish

ENCONTENTS1. Introduction ... 31

EN1. INTRODUCTION1.1 GeneralCongratulations on choosing the Master S series power source. Used correctly, Kemppi products can signicantly increase

EN1.3 Machine introductionMaster S 400 and 5001.5.7. 9.12.6.8.16.10.4.11.13.14.15.2.3.1. Power on pilot lamp2. Overheating pilot lamp3. CV mode pi

EN2. INSTALLATION2.1 Before useThe product is packed in cartons designed specically for them. However, always make sure before use that the product

EN2.4 Welding and earth return cable connections2.4.1 Choosing welding polarity in MMA weldingYou can change the welding polarity by choosing (+) or

EN3.2 Operation functions3.2.1 Power sourceNOTE! Always switch the machine on and o from main switch. Do not use the mains plug for switching! NOT