Kemppi KM 300 User Manual

FastMigKM 300, 400, 500Operating manualBruksanvisningGebrauchsanweisungManual de instruccionesKäyttöohjeManuel d’utilisationManuale d’usoGebruiksaanwi

EN3.3 Use of the control panelThe control panel is used for controlling and monitoring the operation of the power source and the wire feeder. The but

EN3.3.7 Selection of liquid- or gas-cooled MIG gunYou can select a MIG gun cooled with liquid or gas by pressing buttons P3 and P4 simultaneously and

ENThe table below lists the operation parameters and their possible values.Name of parameterName displayedParameter valuesFactory valuesDescriptionPre

EN18.0 m/min).10. Repeat steps 6 – 8 for this higher calibration point.11. The message ‘Suc cES’ appears on the display to indicate that calibration

EN4.5 Machine error codesThe machine always checks its operation automatically during start-up and reports any failures detected. If failures are det

EN5. MAINTENANCEThe utilisation level of the power source and its working environment should be taken into consideration in planning the frequency of

EN6. DISPOSAL OF THE MACHINEDo not dispose of electrical equipment with normal waste!In observance of European Directive 2002/96/EC on waste electric

EN8. TECHNICAL SPECIFICATIONSFastMig™ KM 300 KM 400 KM 500Connection voltage, 3~50/60 Hz400 V, -15 ... +20% 400 V, -15 ... +20% 400 V, -15 ... +20%Ra

www.kemppi.com1903310 1515KEMPPI OYKempinkatu 1PL 13FIN-15801 LAHTIFINLANDTel +358 3 899 11Telefax +358 3 899 [email protected]

OPERATING MANUALEnglish

ENCONTENTS1. Preface ... 31.1 General ...

EN1. PREFACE1.1 GeneralCongratulations on choosing the FastMig™ KM equipment. Used correctly, Kemppi products can signicantly increase the producti

EN1.2 IntroductionThe FastMig KM-series power sources 300, 400, and 500 are MIG power sources designed for demanding professional use in the three-ph

EN2. INSTALLATION2.1 Positioning of the machinePlace the machine on a rm, dry and level surface. Where possible, do not allow dust or other impurit

EN2.3 Connection to mainsFastMig KM power sources are connected to the 400-V three-phase network using the mains cable supplied with the machine. The

EN3. MACHINE USE3.1 Starting of the power sourceStart the power source by turning the main switch (A2) on the front panel to the ‘I’ position. The s